Ken Read’s Puma Team carries a somber tone as their leverage move to split from the fleet, backfires! Mar Mastro finds itself just ahead of last place Team Sanya and aside from the fleet making a huge mistake, will be lucky to reel-in Team Abu Dhabi, which lie just ahead. Team Groupama is nipping at the leader’s heals only 7 NM behind followed By Camper another 30 Nm behind them. The teams made it through the debris fields relatively unscathed. Camper however had a small snag taking a minimal toll…..

[youtube http://www.youtube.com/watch?v=FauUbMtxs-I&w=560&h=315]

Similar Posts

| | | | | |

How to Stow Your Inner Fore-Stay

ByThe Rigging Company

Stowing the inner stay appears to be quite the challenge sometimes. All too many times I have seen systems that are either over complicated, under engineered or are just plain ineffective. Below I describe a method that is very straight forward, simple and effective.  Almost in every case imaginable, the inner stay storage bridle, is the key…

| | | | |

A New Twist on Sails

ByThe Rigging Company

People have been talking more and more about wing sails these days. This technology can’t possibly make its transition into the cruising sailboat market, or can it? Yachting Monthly checks out the new Elan 37 equipped with the Omer Wing Sail. A wing shaped soft sail that can be doused, stowed, and even reefed. [youtube=http://www.youtube.com/watch?v=1Qu_ZgQcr8k&w=560&h=315]…

| | | | | | |

Swageless Mechanical Fittings or Swage Terminals…

ByThe Rigging Company

…Which do you prefer? When talking about wire standing rigging for sailboats, there are two primary ways to secure a fitting to the end of the cable, the swage fitting and the mechanical fitting. One requires a specialized, expensive machine (pictured below) that is used to essentially squeeze or hammer the fitting onto the wire,…

| | | | | |

Spar Finishes

ByThe Rigging Company

Today’s spars are usually made of composite carbon fiber or aluminum extrusions. Both of these mast materials, just like old wooden masts, require a finish. Whereas wooden masts were typically coated with a clear varnish, they could also be found painted. These more traditional finishes were typically brush applied or rolled and tipped. Spray finishes became…

| | | | |

When Replacing Electrical Items in the Mast

ByThe Rigging Company

Re-wiring and replacing the fixtures in the mast is a task that most of us boat owners need to face at some point. Let’s address what needs to happen during this process and what is the most efficient way to do this. First, the mast needs to be un-stepped. Therefore it could be a smart idea to…

Leave a Reply

Your email address will not be published. Required fields are marked *