***Ready-to-assemble Furler/Headstay kits available HERE***
Hood SL Furler Systems offer classic simplicity combined with big boat performance. Combining a proven design, state-of-the-art materials, and heavy-duty construction for maximum reliability and performance, Hood SL furlers are easy to install, use and maintain.
Hood SL Furlers feature a sculptured high load halyard swivel, turnbuckle torque tube to fit over existing turnbuckles, and teflon-coated hard anodized components.
Easy Maintenance
Hood SL furling systems are one of the few systems on the market that can be easily serviced. The ball bearing assembly can be taken apart, cleaned, and new ball bearings installed, which dramatically extends the useful life of the furler.
*NOTE:* The determining factor for unit size is the wire/rod diameter of your headstay; boat length suggestions are just guidelines. Toggle assemblies not included & must be purchased separately.
**Furling line IS NOT included with this furler model. (3/8" double-braid polyester x 80')
Sizing and installation accessories
Model
Suggested boat length
Stay diameter
Chainplate pin
Stay / system length
707 SL
25–33 ft
3/16", 7/32", 1/4", 9/32"
5/16, 3/8, 7/16 or 1/2"
53 ft 3 in maximum system
808 SL
34–46 ft
5/16", 3/8"
1/2 or 5/8"
60 ft 6 in maximum system
Hood catalog pages 4–5. Its imperial stay dimensions are retained because some metric equivalents printed in the catalog conflict. The store’s 808 SL 10-section / 67-ft option exceeds this catalog’s 60-ft-6-in maximum; confirm that configuration with Hood before ordering.
Required parts and installation checks
Confirm ordered kit
Furling line and lower connection
Select single-line furling line separately. Match the model, stay liner, lower pin and existing turnbuckle. The 707 catalog lists its 7/16-inch pin separately. Do not substitute a Harken structural toggle.
What is included?
707 has an integral mounting clevis; 808 uses its model-specific link plates. Confirm the exact supplied pin. The Professional Package adds line-lead parts and a complete stay; bare kits differ.
TRC recommended accessories
TRC recommends
Furling-line lead block kits
Choose a kit for the line diameter, stanchion diameter and deck route. Harken and Schaefer kits can also serve Hood installations when those dimensions match.
Fit a correctly sized restrainer when the halyard lead angle needs it. Match halyard size, mast attachment and furler geometry; these are alternatives, not parts to buy together.