Remove a filter or try another size combination.
Showing 13–24 of 51 results
Easy furling of your asymmetric Spinnaker adapt your FX+ Gennaker/Code sail furler to the use for asymmetric Spinnaker Top Down furling, i.e. from top to bottom (free luff) Free rotating tack fitting No maintenance (mechanism is highly protected) Same features as FX+ mechanisms : tested and strong quick release attachments
Patentened “Start & Go” function Enables to make a break when furling and start furling in again Works clockwise & anti-clockwise
Optimum transmission of rotation Thimble perfectly fitting your FX+ furler For anti-torsion rope Miror polished stainless steel Using thimbles specifically designed for a flying sail furler enables to prevent from the wear of the mechanism jaw and pin and to optimize the transmission of rotation from the mechnanism into the anti-torsion rope.
Smooth & quickly installed quick and safe fitting fo your FX+ furler installation as 3-to-1 or 2-to-1 enables tightening from below the drum possible fitting in case of bowsprit
Colligo Torque Rope – For Asymmetric Furlers & Luff Line Sails Colligo’s torque ropes are custom luff lines for Code Zero sails and torque lines for top-down furling spinnakers. Each line features a Colligo Dux core with a proprietary cover, delivering the best combination of low stretch and torque transmission on the market. These ropes…
Colligo Torque Rope Clamps are designed for use with Code 0, gennaker, and spinnaker furlers that utilize a torsion cable. The clamps are easy to install and can be adjusted as needed. Works with all major furler models, sold per clamp. Note that for some furler systems, two clamps are recommended at one or both…
Selden continuous furling lines are a cover-dependent double braid polyester line. They come factory-spliced into a continuous loop, and have the option of being spliced into a Selden Twin Cam block. Length listed is the length of the loop on deck – e.g. a 4m rope length is an 8m length of rope spliced into…
This snap shackle has a big, well rounded loop allowing the rope to slide with low friction and it can be used to tension a Selden CX with 2:1 purchase. This not only makes for better performance but it also makes it easier to connect the Selden CX to a bowsprit, from the foredeck. The…
TECHNICAL FEATURES PBB 50 • Polymer sheave. • Stainless steel strap for strength and long service life. • Torsional rigid cheeks in glass fibre reinforced polymer to prevent jamming. • Sliding swivel locking mechanism.
The Selden double stanchion fairlead for continuous furling lines are designed to slide over 25-30mm (1 to 1-1/4″) stanchions and feature a spring-loaded metal bracket that can be opened to capture a continuous furling line without having to undo the splice in the line.
The Selden dead-end fitting is installed in the mast to serve as a termination strongpoint for 2:1 halyards. The fitting requires a cutout in the mast and is held in place with four fasteners that thread into the integrated backing plate.
In order to achieve the desired performance of a top-down furling system when using a Code 0 or asymmetric spinnaker, the halyard load must be higher than what normal halyard boxes and stoppers can handle. Therefore, a 2:1 purchase is recommended to be used. The halyard is dead-ended at the mast (preferably with a swivel…
No products in the cart.
|
Uploaded
Failed
|
 |
