Colligo Terminator end fittings are the only spliceable, lashable, and pinnable end fittings available that meet Hampidjan’s recommended minimum 5/1 bending ratio for Dyneema. This is essential for long term durability of Dyneema-based lines, as tight bending radii can cause compressive stresses that weaken the line considerably.

Clevis pin holes come with a bushing installed, sized at the smaller pin diameter. This bushing can be removed to accommodate larger pins. Some pin size flexibility is designed into these parts – meaning you can go slightly smaller if you’re in between sizes. A little play in the pin is acceptable; or better yet, a thicker bushing can be installed by the user.

The standard termination type is the “Pin & Lashing” style, which has both a clevis pin hole for a fork or toggle to pin to, as well as smaller holes for a lashing attachment.

The “Narrow Pin” termination type features a relief area on the Terminator that allows the fitting to interface with narrow-width turnbuckles such as Hayn. These do not feature lashing holes.

The “Flex” termination type can accept line diameters from 7-13mm and is designed for dynamic as well as static loads. There is no clevis pin hole. The fitting features three small sheaves allowing for on-the-fly adjustment with an up to 1/4″ control line on up to a 7/1 purchase.

Larger and custom sizes available upon request.